搅拌一体车的使用已经被广泛化了，主要应用于各地施工现场，所以如果想更好的使用它，就要对有关问题进行一个了解，这样才能避免不好的情况出现，那么今天来分析一个问题--搅拌一体车运转时会什么会出现高温现象？

　　The use of mixing vehicle has been widely, mainly used in the construction site, so if you want to better use it, it is necessary to carry out an understanding of the relevant problems, so as to avoid the bad situation, so today to analyze a problem -- what will appear high temperature phenomenon when mixing vehicle operation?

　　从生产实践来看，如果发现操作面板上的电流表指示的电流间歇性上升，常见的原因是：设备各部分运行正常时，需要查找泥勺头，这时泥勺头很可能出现松动，勺头松动是造成电流周期性、间歇性上升的主要原因。当然，您还应该检查勺子底部是否有东西阻止勺子旋转。如果电流继续上升，没有回到额定电流，则可能是负载过大或电压过低造成的。

　　From the production practice, if the current indicated by the ammeter on the operation panel is found to rise intermittently, the common reason is: when each part of the equipment runs normally, the mud spoon head needs to be searched, and then the mud spoon head is likely to loosen, which is the main reason for the periodic and intermittent rise of the current. Of course, you should also check the bottom of the spoon for anything that prevents the spoon from spinning. If the current continues to rise and does not return to the rated current, it may be caused by too much load or too low voltage.

　　是喂料量大造成的，需要调整喂料量。是机械问题导致负载过大，应该停止。但是，如果是低电压造成的，则纯粹是外接电源造成的。积极的方法是观察电流是否有大的变化和电机温升。如果这种现象突然发生，往往是由于粒径增大所致。矿石硬度的变化可能是由不同的采矿表面和成分引起的。在这两种情况下，搅拌过程都会引起相应的变化。

　　It is caused by large feeding volume, which needs to be adjusted. Mechanical problem causing excessive load and should be stopped. However, if it is caused by low voltage, it is purely caused by external power supply. A positive approach is to observe whether there is a large change in current and motor temperature rise. If this phenomenon occurs suddenly, it is usually caused by an increase in particle size. Variations in mineral hardness may be caused by different mining surfaces and compositions. In both cases, the stirring process causes a corresponding change.

　　另外，搅拌一体车生产厂家展开的检测运动对车主长短常有益处，车主可以应用这些检测运动对喜欢车进行具体体检，实时发现并扫除一些潜在的毛病，然后省去了未来能够呈现的高额维修保护费用。搅拌一体车在保养时也要会保养才可以，错误的保养方法不仅会使设备的质量有所下降，严重的可能会损坏某些零件，这在很大程度上降低了它的使用寿命。

　　In addition, the free detection movement of the mixing vehicle manufacturer is very beneficial to the owner. The owner can use the detection movement to carry out specific physical examination of the car, find and sweep away some potential problems in real time, and then save the high maintenance and protection costs that can be presented in the future. Mixing vehicle in the maintenance of maintenance can also be maintained, the wrong maintenance method will not only make the quality of the equipment decreased, serious may damage some parts, which to a large extent reduces its service life.

　　搅拌一体车运转时会什么会出现高温现象？以上内容中已经说明了，希望大家可以好好了解到。大家在日后的保养时一定要注意，千万不要犯错误。更多内容的了解，大家可以来我们网站www.jfhntjbc.com咨询。

　　What will appear high temperature phenomenon when the mixing vehicle runs? The above content has been explained, I hope you can have a good understanding. We must pay attention to the maintenance in the future, do not make mistakes. For more information, you can come to our website www.jfhntjbc.com.