您好,欢迎光临中科聚峰机械有限公司网站! 主营自动搅拌车,搅拌一体车,自动上料搅拌车等各种规格的产品。

自动上料搅拌车行业持续先行者!

点击拨打服务热线:4008791999

您的位置:首页 - 新闻中心 > 公司新闻 >

搅拌车系统出现气压不足要尽快解决

发布时间:2022-07-15 来源:http://www.jfhntjbc.com/ 浏览量:

概述: 搅拌车使用的时候,遇到出现气压不足的情况,要怎么来处理,作为搅拌一体车厂家,让小编带大家共同了解一下搅拌车系统出现气压不足要如何
搅拌车使用的时候,遇到出现气压不足的情况,要怎么来处理,作为搅拌一体车厂家,让小编带大家共同了解一下搅拌车系统出现气压不足要如何解决。
When the mixer truck is used, how to deal with the problem of insufficient air pressure? As a manufacturer of integrated mixer truck, let me show you how to solve the problem of insufficient air pressure in the mixer truck system.
如果搅拌车液压泵有油输出的情况发生,我们可以及时查看其工作是否正常。如不正常,有可能是压力油路中的某个设备配件被卡在了其它原因,处于回油位置,导致压力油路和溢流回路短路的情况发生,也可能是管接头有松动的情况发生。
If the hydraulic pump of the mixer truck has oil output, we can check whether it works normally in time. If it is abnormal, it may be that a device accessory in the pressure oil circuit is stuck in the oil return position for other reasons, resulting in a short circuit between the pressure oil circuit and the overflow circuit, or a loose pipe joint.
当我们在油路中的某些设备漏油,或液压缸、液压马达密封被损坏。排除的方法是直接拆掉相关设备进行清洗,看看是否有相应的设备损坏,该更换就更换,该检查一下。
When some equipment in the oil circuit leaks oil, or the seals of hydraulic cylinders and hydraulic motors are damaged. The method of elimination is to directly dismantle the relevant equipment for cleaning, and see whether there is corresponding equipment damage. Replace it when it is time to replace it, and check it.
搅拌一体车
看看自动搅拌车的液压泵是不是可以输出液压油的。如称新型液压泵,无液压油,有可能是泵体有缺陷,让吸油腔与压油腔有相通的情况发生,失去了压油能力,应及时找到更换。如果没有新的液压泵,没有液压油输出,就有可能是转向不当,部件磨损严重或损坏,及时更换。
See if the hydraulic pump of the automatic mixer can output hydraulic oil. For example, if the new hydraulic pump has no hydraulic oil, it may be that the pump body has defects, so that the oil suction chamber is connected with the oil pressure chamber. If the oil pressure capacity is lost, it should be found and replaced in time. If there is no new hydraulic pump and no hydraulic oil output, it may be improper steering, serious wear or damage of components, which should be replaced in time.
搅拌一体车的液压系统可以设定正常压力,有些管道或液压缸在中间没有压力,可能是因为管路、小孔或节流阀、换向阀等部位堵塞。因此要仔细检查检查压力是否有油通过,找出原因,但后来就排除了。
The hydraulic system of the integrated mixer can set the normal pressure. Some pipelines or hydraulic cylinders have no pressure in the middle, which may be due to the blockage of pipelines, small holes, throttle valves, reversing valves and other parts. Therefore, it is necessary to carefully check whether there is oil passing through the pressure to find out the cause, but it was later eliminated.
搅拌一体车的液压泵输出流量随着压力的增加而明显降低,并且压力不能达到规定的值,则是由于液压泵磨损后的间隙加大。排出法是通过测定液压泵的容积效率,确定该泵是否能够继续使用,对磨损严重的产品,一定要进行修理或更换。
When the output flow of the hydraulic pump of the integrated mixer truck decreases significantly with the increase of pressure, and the pressure cannot reach the specified value, it is due to the increase of the clearance after the hydraulic pump is worn. The discharge method is to determine whether the hydraulic pump can continue to be used by measuring the volumetric efficiency of the pump. Products with serious wear must be repaired or replaced.
以上就是今天为大家介绍的关于问题以及注意事项的全部内容,希望对大家能有所帮助,想要了解更多内容可以电话联系我们或者关注我们的网站http://www.jfhntjbc.com,我们的工作人员会及时与您取得联系。
The above is all about the problems and precautions introduced to you today. I hope it can help you. If you want to know more, you can contact us by phone or follow our website http://www.jfhntjbc.com , our staff will contact you in time.

截屏,微信识别二维码