What are the key factors for driving a fully automatic mixer?

1.全自动一体式搅拌车启动卡车发动机后，以低速运行搅拌机约10分钟，以使液压油温度高于20°C。

1. After starting the truck engine, run the mixer at low speed for about 10 minutes to make the hydraulic oil temperature higher than 20 ℃ ° C。

2.在此之前，将搅拌桶上下颠倒。

2. Before that, turn the mixing drum upside down.

3.搅拌一体车卡车运输的混凝土坍落度必须少为8厘米。从混凝土进入储罐到卸货的高温不应超过2小时，而在雨天的低温不应超过2.5小时。

3. The slump of concrete transported by mixer truck must be at least 8 cm. The high temperature from concrete entering the storage tank to unloading should not exceed 2 hours, and the low temperature in rainy days should not exceed 2.5 hours.

4.搅拌一体车在将混凝土卸到卡车上之前，搅拌箱应以10-12 rpm的速度旋转1分钟。

4. The mixing tank shall rotate at a speed of 10-12 rpm for 1 minute before the truck unloads the concrete.
                    

5.搅拌一体车.混凝土自动搅拌机卸载卡车后，使用卡车软管清洁进水口，排水漏斗，卸载箱等零件，以车厢各个部位的污垢和残留的混凝土。倒入150-200升纯净水桶中。在返回过程中，缓慢旋转混合槽以清洁内壁，以防止残留的炉渣粘附到混合槽壁和混合叶片上，排干水，然后重新填充。

5. After unloading the truck, use the truck hose to clean the water inlet, drainage funnel, unloading box and other parts, so as to remove the dirt and residual concrete in all parts of the car. Pour into 150-200 liter clean water bucket. During the return process, the mixing tank is slowly rotated to clean the inner wall, so as to prevent the residual slag from adhering to the mixing tank wall and mixing blades, drain the water, and then refill.

6.从搅拌一体车运输混凝土时，发动机转速应在1000-1400 rpm的范围内，以确保发动机扭矩。在运输混凝土的过程中，为了驾驶，车辆的速度不得超过40 km / h。

6. When transporting concrete from the mixer truck, the engine speed should be in the range of 1000-1400rpm to ensure the engine torque. In the process of transporting concrete, in order to drive safely, the speed of the vehicle shall not exceed 40 km / h.

7.使用搅拌一体车完成物料装载后，清洁搅拌器的内部和主体，以使搅拌器中没有残留的混凝土。

7. After using the mixer truck to load materials, clean the inside and main body of the mixer so that there is no residual concrete in the mixer.

这是对搅拌一体车的驱动要点的介绍，您了解吗？

This is an introduction to the driving points of mixer truck. Do you understand?