您好,欢迎光临中科聚峰机械有限公司网站! 主营自动搅拌车,搅拌一体车,自动上料搅拌车等各种规格的产品。

自动上料搅拌车行业持续先行者!

点击拨打服务热线:4008791999

您的位置:首页 - 新闻中心 > 行业资讯 >

不能错过的搅拌一体机的操作秘籍!

发布时间:2022-04-08 来源:http://www.jfhntjbc.com/ 浏览量:

概述:     搅拌一体机对保证工程质量、提高施工效率起着十分重要的作用,但是在施工作业中也要注意安全使用搅拌一体机,下面我们就给大家介
  
  搅拌一体机对保证工程质量、提高施工效率起着十分重要的作用,但是在施工作业中也要注意安全使用搅拌一体机,下面我们就给大家介绍下搅拌一体机的操作方面的注意事项。
  All in one stirring machine plays a very important role in ensuring the quality of the project and improving the efficiency of the construction, but we should also pay attention to the safe use of all in one stirring machine in the construction operation. Here we will introduce the precautions for the operation of all in one stirring machine.
  将搅拌一体机行驶停放到工作区,拉好手刹将档位拨至空挡熄火;下车观察搅拌一体机所在位置是否在坚实的地面上,尽量将搅拌一体机停在泵送臂架工作范围内。观察好地形后,将电控箱操作面板上的行车开关转换至泵送位置,启动底盘发动机,将底盘档位挂到6档。检查各处的急停开关是否打开。
  The mixing machine will drive and park to the working area, pull the handbrake to switch to neutral and flameout; Get off to observe whether the position of the all-in-one stirring machine is on the solid ground, and try to stop the all-in-one stirring machine within the working range of the pumping arm. After observing the terrain, switch the running switch on the operation panel of the electric control box to the pumping position, start the chassis engine, and put the chassis gear into 6th gear. Check whether emergency stop switches are on everywhere.
  将臂架支腿转换开关切换到支腿位置,在依次将六条泵机支腿展开。展开支腿时,应注意将支腿下方垫木方,必须用支承板或辅助方木来增大支承表面积,并保持整车的平衡。将臂架支腿转换开关切换到臂架位置,将大臂伸开。
  Switch the boom leg switch to the leg position and expand the six pump legs in turn. When the legs are expanded, attention should be paid to the wooden pad under the legs. Supporting plates or auxiliary square wood must be used to increase the supporting surface area and maintain the balance of the vehicle. Switch the boom leg transfer switch to the boom position and extend the big arm.
  拔出搅拌机定位销,将搅拌机推动到工作位置,插好定位销。放下上料斗上下滑道,连接好固定螺栓。注意:下滑道应与地面接触并保持受力,悬空易导致滑道变形。
  Pull out the positioning pin of the mixer, push the mixer to the working position, and insert the positioning pin. Lower the upper hopper up and down the slideway and connect the fixing bolts. Note: the slide should be in contact with the ground and keep the force, hanging easy to cause deformation of the slide.
  检查发电机组空气开关是否处于断开状态。如带负荷启动,或影响发电机消磁。调整油门至发电机组仪表正常状态。
  Check whether the generator set air switch is off. Such as load start, or affect the generator demagnetization. Adjust throttle to generator set instrument normal condition.
  泵送工作开始:铲车沙子4包水泥搅拌均匀后放入搅拌一体机料斗等待;搅拌混凝土;开始泵送砂浆,再将搅拌好的混凝土放入料斗连续泵送避免堵管。
  Start pumping work: forklift sand 4 bags of cement mixing evenly into the mixing machine hopper waiting; Mixed concrete; Start pumping mortar, and then mix the concrete into the hopper continuous pumping to avoid blocking the pipe.
  清洗工作:打开搅拌一体机料斗卸料门,将料斗内的混凝土清理干净;打开搅拌机卸料门冲洗料斗;打开出料口第一根180弯头上的观察口,塞入海绵球后关闭观察口;将搅拌一体机料斗注满水,启动泵送将海绵球泵送出管道;打开料斗卸料门,将臂架垂直立起,S管摆至中位,放掉管道里的水。
  Cleaning work: open the hopper unloading door of the mixing machine, clean the concrete in the hopper; Open the discharging door of the mixer to flush the hopper; Open the observation port on the first bend 180 of the discharge port, insert the sponge ball and close the observation port; Fill the hopper of the mixing machine with water, and start pumping to pump the sponge ball out of the pipe; Open the hopper discharge door, erect the boom vertically, place the S tube in the middle position, and drain the water in the pipe.
  关闭发电机组:断开空气开关;将发电机组柴油机转速降至低速运转30秒后关闭发电机组。
  Turn off the generator set: disconnect the air switch; Turn down the diesel engine speed of the generator set to low speed for 30 seconds and then close the generator set.
  收车:将搅拌机收到行车状态,插好定位销;收臂架;收支腿。将底盘档位拨至空挡,将转换开关切换行车状态。
  Car: the blender received the running state, plug the positioning pin; Revenue boom; Balance of payments. Switch the chassis gear to neutral and switch the driving state.
  所以这才说不能错过的搅拌一体机的操作秘籍!当然要想搅拌一体机使用前后不会出现大的问题,那么在平常中就要做好的相关的准备工作以及检查工作,更多内容就来www.jfhntjbc.com/咨询吧。
  So this is to say that can not miss the operation of the all-in-one mixing machine secrets! Of course, if you want to use the all-in-one mixing machine before and after there will not be a big problem, then in the usual time to do the relevant preparation and inspection work, more content to www.jfhntjbc.com/ consultation.

截屏,微信识别二维码