如果发现搅拌体上有伤痕，检查伤痕的程度。如果只是表面油漆上很轻微的划痕，立即用混合物处理，擦拭方法是直擦。疤痕消失后，在打蜡前用更细的混合物擦拭。

If there are scars on the mixing body, first check the extent of the scars. If it is only a slight scratch on the surface paint, immediately treat it with a mixture and wipe it directly. After the scar disappears, wipe it with a finer mixture before waxing.

所有的搅拌一体车在使用过程中都有划痕，一个好的修复方法是用与车身相同的涂层剂填充划痕。涂层剂可涂一次、两次或三次。次数越多，就会越干净。但是整个搅拌体的均匀处理也很重要。

All mixer trucks have scratches during use. A good repair method is to fill the scratches with the same coating agent as the body. The coating agent can be applied once, twice or three times. The more times, the cleaner it will be. However, the uniform treatment of the whole stirring body is also very important.

对于较深的伤痕，关键是观察金属表面是否外露。如果看不到金属表面，则不会生锈，可以集中精力涂饰面漆。用笔尖轻拍它，等待油漆完全干燥。

For deeper scars, the key is to observe whether the metal surface is exposed. If you can't see the metal surface, it won't rust and you can concentrate on finishing the finish. Tap it with the tip of your pen and wait for the paint to dry completely.

用彩色腻子可以很好地修复深而细的疤痕。在疤痕上使用砂纸，不要随意扩大疤痕表面，去除污垢很重要。小心地涂抹腻子，使其完全进入内部。然后涂抹混合物，打蜡并完成工作。

Deep and thin scars can be well repaired with colored putty. Use sandpaper on the scar. Do not enlarge the scar surface at will. It is very important to remove dirt. Carefully apply putty so that it enters completely into the interior. Then apply the mixture, wax and finish the work.

发现车身锈迹后，立即着手。如果不理会，锈斑会逐渐扩大。防止生锈的方法是用砂纸清洁它，或者使用改变生锈点的化合物。

When the rust is found on the car body, it shall be solved immediately. If ignored, the rust will gradually expand. The way to prevent rust is to clean it with sandpaper or use compounds that change the rust point.

贴在门和行李箱周围的防水条很容易剥落和扭曲。但如果没有破裂或变形，则可以再次使用，只需重新粘贴即可，以防止漏水。用保护剂恢复橡胶本身的弹性也很重要。

The waterproof strip attached around the door and trunk is easy to peel off and twist. However, if there is no crack or deformation, it can be used again. Just paste it again to prevent water leakage. It is also important to restore the elasticity of rubber itself with protective agent.

搅拌一体车的机油过多或过少都会影响发动机。理想量接近油垢上限。对于补充油，尽量准备与所用油品级相同的产品。注意不要溅到发动机周围，每月检查一次。

Too much or too little oil in the integrated mixer will affect the engine. The ideal amount is close to the upper limit of oil scale. For make-up oil, try to prepare products with the same grade as the oil used. Be careful not to splash around the engine. Check it once a month.

保险公司处理伤疤的方法是把毛刺刮掉，在坑洼处涂上腻子，使之光滑。专用腻子，备有各种颜色，选择相近的颜色。对于与车身同色的保险杠，喷漆非常重要。

The way insurance companies deal with scars is to scrape off the burrs and apply putty to the pits to make them smooth. Special putty, available in various colors, choose similar colors. For bumpers in the same color as the body, painting is very important.

以上就是搅拌一体车常用的应对擦痕、掉漆、小碰撞的维修与保养办法，希望对广大朋友能有一些帮助。更多相关的内容您可以来网站www.jfhntjbc.com咨询。

The above are the common repair and maintenance methods for the integrated mixer to deal with scratches, paint falling off and small collision. I hope it can be of some help to the majority of friends. For more information, please visit www.jfhntjbc.com Com consulting.