您好,欢迎光临莱州聚峰机械有限公司网站! 主营自动搅拌车,搅拌一体车,自动上料搅拌车等各种规格的产品。

自动上料搅拌车生产厂家

点击拨打服务热线:4008791999

您的位置:首页 - 新闻中心 > 常见问题

在操作搅拌一体车时应注意哪些准确规范

发布时间:2022-07-06 来源:http://www.jfhntjbc.com/ 浏览量:0

概述:操作是搅拌一体车完成其工作任务的基本保证,也是搅拌车操作、维修和周围施工人员人身的可靠保证。那么在操作搅拌车时应注意哪些准
操作是搅拌一体车完成其工作任务的基本保证,也是搅拌车操作、维修和周围施工人员人身的可靠保证。那么在操作搅拌车时应注意哪些准确规范内容呢?
Safe operation is the basic guarantee for the mixer to complete its work tasks, as well as the reliable guarantee for the operation, maintenance and personal safety of surrounding construction personnel. So what precise specifications should we pay attention to when operating the integrated mixer?
1.蓄电池
1. Battery
蓄电池只能用氮气冲洗,不能用氧气、氢气等易燃易爆气体冲洗。
The battery can only be flushed with nitrogen, not oxygen, hydrogen and other flammable and explosive gases.
2.应急关闭按钮
2. Emergency shutdown button
输送泵车上设有一系列紧急停车按钮,分别设置在支腿控制阀、有线无线遥控系统和控制箱之上。在紧急情况之下,只需按下其中一个应急关机按钮,机器就可以关机。如果应急停机按钮出现故障,机器在紧急情况下不能急速停机。
A series of emergency stop buttons are set on the delivery pump truck, which are respectively set on the outrigger control valve, wired wireless remote control system and control box. In an emergency, just press one of the emergency shutdown buttons to shut down the machine. If the emergency stop button fails, the machine cannot be shut down quickly in an emergency.
因此,每次开始工作后务必要检查应急关闭按钮的功能。当按下应急停机按钮时,机器的电气系统被切断,导致电磁阀关闭等,如果液压系统出现泄漏,会导致动臂下沉等问题,按下应急停机按钮无法。
Therefore, it is necessary to check the function of the emergency shutdown button after each start of work. When the emergency stop button is pressed, the electrical system of the machine is cut off, causing the solenoid valve to close, etc. if the hydraulic system leaks, it will cause problems such as boom sinking, which cannot be solved by pressing the emergency stop button.
搅拌一体车
3.抽水作业
3. Pumping operation
启停泵时,应与末端软管的操作人员联系,末端软管的弯曲半径不小于1m,不允许弯曲;在拆卸堵塞的管道后,应将其泵回2-3次,确认管道无残余压力之后再拆卸。
When starting and stopping the pump, contact the operator of the end hose. The bending radius of the end hose is not less than 1m, and bending is not allowed; After dismantling the blocked pipeline, pump it back for 2-3 times and confirm that there is no residual pressure in the pipeline before dismantling.
4.动臂操作
4. Boom operation
当动臂从折叠状态伸出或缩回时,务必要按指定次序执行。动臂回转操作务必要在动臂全然离开动臂支架之后进行。当风速为16-17ms,处于风暴状态或风速达到8级或超过时,不得使用吊杆。动臂不得用于提升操作。
When the boom extends or retracts from the folded state, it must be carried out in the specified order. The boom rotation operation must be carried out after the boom completely leaves the boom support. When the wind speed is 16-17ms, it is in a storm state or the wind speed reaches level 8 or more, the suspender shall not be used. The boom must not be used for lifting operations.
5.术后检查
5. Postoperative examination
吊杆应在吊杆支架之上全然缩回;支腿也应全然缩回,并插入锁销。控制台的电源开关应处于“关闭”位置。
The suspender should be completely retracted on the suspender support; The outrigger should also be fully retracted and the locking pin inserted. The power switch of the console should be in the "off" position.
以上就是问题解答的相关内容了,希望能够帮助到大家,如对这一问题还存在任何疑问,都欢迎关注我们网站http://www.jfhntjbc.com并咨询我们的工作人员,将竭诚为您服务。
The above is the relevant content of the question answer. I hope it can help you. If you still have any questions about this problem, you are welcome to follow our website http://www.jfhntjbc.com And consult our staff, will serve you wholeheartedly.

截屏,微信识别二维码