您好,欢迎光临莱州聚峰机械有限公司网站! 主营自动搅拌车,搅拌一体车,自动上料搅拌车等各种规格的产品。

自动上料搅拌车生产厂家

点击拨打服务热线:4008791999

您的位置:首页 - 新闻中心 > 常见问题

搅拌一体车使用期间这些弊端要避免

发布时间:2022-10-26 来源:http://www.jfhntjbc.com/ 浏览量:0

概述:搅拌一体车是工程建造中必不可少的设备,但是由于是自动设置,使用时间长后部分功能会影响整体使用,下面跟着小编了解下搅拌一体车使用期间
搅拌一体车是工程建造中必不可少的设备,但是由于是自动设置,使用时间长后部分功能会影响整体使用,下面跟着小编了解下搅拌一体车使用期间这些弊端要避免吧。
The all-in-one mixer is an indispensable equipment in engineering construction. However, due to its automatic setting, some functions will affect the overall use after a long time of use. Let's follow the small compilation to understand that these drawbacks should be avoided during the use of the all-in-one mixer.
一是齿轮箱的正常压力范围为1.08~1.47MPa,压力低于1.08MPa。认为变速油压太低,这将导致搅拌一体车的驱动力不足,整机弱,齿轮不起动。减压阀的功能是通过压力调节弹簧将较高的输入压力调节到规定的输出压力,并确保输出压力的平衡。一旦减压阀的压力调节弹簧损坏,变速箱将不能保证正常的输出压力。
First, the normal pressure range of the gearbox is 1.08~1.47MPa, and the pressure is lower than 1.08MPa. It is believed that the speed change oil pressure is too low, which will lead to insufficient driving force of the mixer, weak whole machine and gear failure to start. The function of the pressure reducing valve is to regulate the higher input pressure to the specified output pressure through the pressure regulating spring, and ensure the balance of the output pressure. Once the pressure regulating spring of the pressure reducing valve is damaged, the transmission will not be able to guarantee the normal output pressure.
二是压力调节器没有适当调整。压力调节阀通过压力调节阀芯控制变速器的输出压力。如果输出压力太小,变速箱油压将太低。
Second, the pressure regulator was not properly adjusted. The pressure regulating valve controls the output pressure of the transmission through the pressure regulating valve core. If the output pressure is too low, the transmission oil pressure will be too low.
搅拌一体车
三是管道油封严重漏油。检查变速箱油盘到变速箱泵吸入管路是否泄漏。如果发现漏油,请修理或更换新线路。
Third, the oil seal of the pipeline leaks seriously. Check the transmission oil pan to the transmission pump suction line for leaks. If oil leakage is found, repair or replace the circuit.
车辆保养方面:
Vehicle maintenance:
1、要定期更换机油,液压油。
1. Change the oil and hydraulic oil regularly.
2、车辆底盘的保养周期要严格履行,有些厂家如果客户没有严格履行,或者在其他修理厂更换了零部件,后来造成车辆损失的,是不予索赔的。
2. The maintenance cycle of the vehicle chassis should be strictly followed. Some manufacturers will not claim for damages if the customer does not strictly follow the maintenance cycle, or if they replace parts in other repair shops.
3、每天用完车都要仔细清洗罐体外表,内腔,否则混凝土凝结以后你的车装料会越装越少的。
3. Carefully clean the outer surface and inner cavity of the tank after using the car every day, otherwise your car will be less and less loaded after the concrete is set.
除了清洗残余料,还要把车辆比如托轮、辊道之类的地方清理干净,常常会有石子残留,日积月累会降低你的钢结构正常使用寿命。所以说在了解好搅拌车的使用要点,还要对其进行定期的维护,更多相关内容就来我们网站http://www.jfhntjbc.com咨询吧!
In addition to cleaning the residual materials, you should also clean the vehicle, such as the supporting wheel and roller table. There are often stone residues, which will reduce the normal service life of your steel structure over time. Therefore, in order to understand the key points of using the mixer well, we should also carry out regular maintenance on it. More relevant information can be found on our website http://www.jfhntjbc.com Consult!

截屏,微信识别二维码