您好,欢迎光临莱州中科聚峰有限公司网站! 主营自动搅拌车,搅拌一体车,自动上料搅拌车等各种规格的产品。
15098551508
自动上料搅拌车行业持续领跑者!
点击拨打服务热线:4008791999

您的位置:首页 - 技术问答 > 常见问题 >

常见问题

混凝土搅拌车磨合期需要注意哪些问题?

发布时间:2020-12-28 来源:http://www.jfhntjbc.com/ 浏览量:

概述:混凝土搅拌车主要是由专用车底盘、上装罐体及液压系统等组成,近几年受房产业的影响,搅拌车的使用越来越多,因为搅拌车属于专用车,在操作
混凝土搅拌车主要是由专用车底盘、上装罐体及液压系统等组成,近几年受房产业的影响,搅拌车的使用越来越多,因为搅拌车属于专用车,在操作上跟其它车辆还是有区别的,尤其是新买的搅拌车在磨合期需要十分注意,下面就给大家介绍一下混凝土搅拌车在磨合期需要注意哪些问题。
Concrete mixer truck is mainly composed of special truck chassis, upper tank body and hydraulic system. In recent years, affected by the real estate industry, the use of mixer truck is more and more, because the mixer truck belongs to special truck, and it is different from other vehicles in operation, especially the newly bought mixer truck needs to pay attention in the running in period. The following is to introduce the concrete mixer truck in grinding What problems should be paid attention to during the period.
1. 新购买的混凝土搅拌车,使用半个月之后就需要紧固整车的螺栓,特别是连接副梁和底盘之间的“U型”螺栓,其次是减速机与罐体之间的螺栓,紧固时,拧紧力矩应达到300-350Nm。
1. The newly purchased concrete mixer needs to tighten the bolts of the whole vehicle after half a month's use, especially the "U" bolts between the auxiliary beam and the chassis, followed by the bolts between the reducer and the tank. When tightening, the tightening torque should reach 300-350nm.
2. 液压系统也是非常重要的,液压系统在初次使用250小时后一定要更换高压抗磨液压油,以后每使用2500小时就要更换一次,但是换油的时间至多不得超过一年,换油的同时尽量更换散热器滤芯。
2. The hydraulic system is also very important. The high-pressure anti-wear hydraulic oil must be replaced 250 hours after the first use of the hydraulic system. In the future, it must be replaced every 2500 hours, but the oil change time shall not exceed one year at most. The radiator filter element shall be replaced as much as possible when changing the oil.
3. 减速机初次使用250小时要更换重负荷的齿轮油,以后每隔2500小时更换一次,但是换油时间不得超过一年。
3. The gear oil with heavy load shall be replaced 250 hours after the reducer is first used, and then every 2500 hours, but the oil change time shall not exceed one year.
                  自动上料搅拌车
4. 在混凝土搅拌车的正常使用过程中,当散热器真空表读数超过0.03兆帕时,应立即更换液压油和滤芯。
When the vacuum meter is in normal use, the radiator should be replaced immediately.
5. 散热器温控开关是自动控制风扇的运转和停止的,不要随意的调动。连接底盘和液压泵之间的传动轴应每周加注锂基脂润滑油。
5. The radiator temperature control switch is used to automatically control the operation and stop of the fan. Do not adjust it at will. The transmission shaft between the chassis and the hydraulic pump should be filled with lithium grease every week.
6. 混凝土搅拌车搅拌罐每次卸完料都必须清洗罐体内外及进出料装置,以防罐内粘过多的混凝土,一般在三个月左右就要进行一次彻底的清理。 搅拌罐导轨与托轮之间的接触面每周需要加注锂基脂润滑油。 罐体检查孔,就是“人孔”用于罐体内部维修的,必要时,可打开放出罐内的预拌混凝土。
6. The inside and outside of the tank and the feeding and discharging devices must be cleaned every time the concrete mixing tank of the concrete mixer is unloaded, so as to prevent excessive concrete sticking in the tank. Generally, a thorough cleaning is required in about three months. The contact surface between guide rail and supporting wheel of mixing tank needs to be filled with lithium grease every week. The manhole is used for the internal maintenance of the tank. If necessary, the ready mixed concrete in the tank can be opened and discharged.
7. 托轮、卸油转轴、操纵系统等主要部件每周都需要加注锂基脂润滑油,保证其灵活性。
7. The supporting wheel, oil unloading shaft, control system and other main parts need to be filled with lithium grease every week to ensure their flexibility.
技术支持:济南诺商  XML   TXT   
本网站部分资源来自互联网,如有侵权,请联系我们及时删除
分享按钮

截屏,微信识别二维码

微信号:

点击微信号复制,添加好友

 打开微信